Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Rotobrush Air Duct Cleaning in Fresno: What to Know First
Rotobrush air duct cleaning in Fresno typically runs $450 to $1,100 for a full system, and we complete most residential jobs in a half day. We’re an independent Rotobrush service provider, not a manufacturer-authorized shop, which means we recommend the fix that actually makes sense for your ductwork, not the one a corporate program tells us to push. This page is for Rotobrush owners in Fresno who want straight answers on how their system fails, what it costs to clean it properly, and who exactly shows up at the door. Call (559) 272-4989 and a live person answers, day or night.
How Rotobrush Products Fail – and How We Fix Them
Rotobrush built its name on portable duct cleaning machines, and a lot of Fresno contractors own the classic AiR+ or the newer Roto-Vision models. We see the same issues repeat across the city. Here’s what actually goes wrong and what we do about it.
- AiR+ brush head wear on long residential runs. The nylon bristles on the AiR+ brush head flatten after a few hundred feet of duct, especially in older Fresno ranch homes where return ducts run long and tight. Owners report the machine “just isn’t pulling much anymore.” We replace the brush head with OEM when the customer wants factory spec, or a quality aftermarket equivalent that costs about 30% less and wears the same in our experience.
- Roto-Vision camera fogging in summer. Fresno heat does a number on the camera lens seals in Roto-Vision units. The lens fogs mid-inspection, and suddenly you can’t document the job. We reseal the lens housing and replace the desiccant pack before cleaning starts, so your video inspection actually holds up through the whole run.
- Vacuum bag saturation from fine Valley dust. Rotobrush systems use high-efficiency bags, but the talcum-fine dust we get in Fresno settles into the bag pleats and chokes suction fast. When suction drops, the brush is just spinning, not extracting. We swap in a fresh bag and check the HEPA pre-filter before we start pulling anything out of your ducts.
- Collection drum seal leaks on older units. The foam gasket between the collection drum and the vacuum housing degrades over time, especially in dry climates. Air leaks around the seal mean dust blows out instead of being captured. We replace the gasket and run a smoke test to confirm the seal before cleaning your system.
- Drive belt slippage on the brush motor. When a Rotobrush has been in service for a while, the brush motor belt stretches and slips. The brush turns slower than it should, and the job takes twice as long with worse results. We tension or replace the belt before we touch your ductwork, because a machine that’s not right at the source won’t clean right at the vent.
Styles & brands we work with




Our Rotobrush Air Duct Cleaning Process
Every Rotobrush cleaning job we run in Fresno follows the same sequence. No shortcuts, no mystery steps.
- 1
You call (559) 272-4989. A live person answers, asks about your system, and sets a time. The tech’s name and photo come to you before the visit.
- 2
Walkthrough and written price. The technician shows photo ID at the door, walks the system with you, and puts the full price in writing before any work starts. No per-vent calculations, no add-ons later.
- 3
Equipment check. We inspect the Rotobrush unit’s brush head, seals, bag, and belt before we connect it to your ductwork. A machine problem gets fixed before it becomes your cleaning problem.
- 4
Negative-pressure extraction with brush agitation. We seal each register, run the Rotobrush brush and vacuum through both supply and return runs, and capture what comes out. You’ll see it in the collection drum.
- 5
Video inspection. We run the camera through completed runs so you see the before and after with your own eyes. Before-and-after photos are included.
- 6
Written guarantee. Every cleaning and repair is backed by the 365-Day Done Right Promise in writing. If it’s not right, we come back and make it right.
See the difference
Before
After
Before
After
Before
AfterWhat Rotobrush Air Duct Cleaning Costs in Fresno
Straight numbers, the way we quote them before anyone starts work.
- Full residential system (supply and return): $450 to $850. Most Fresno homes fall in the $550 to $700 range depending on square footage and register count.
- Supply or return only: $250 to $450. We’ll tell you honestly if doing half is worth your money or if you’re better off doing the whole system at once.
- Full system plus dryer vent cleaning: $550 to $1,100. We bundle the dryer vent at a lower rate when it’s on the same visit.
- Commercial or multi-unit systems: $900 and up. Pricing depends on the number of units, duct length, and access. We walk it before we quote it.
What moves the price: how many registers you have, how long the duct runs are, how much buildup has accumulated, and whether it’s a single-story ranch or a two-story with hard-to-reach supply trunks. The written price you get is the price you pay. Call (559) 272-4989 for an exact quote. Estimates are free.
Why Fresno Homeowners Call Linden Air Duct Fresno for Rotobrush Work
Marcus Veale grew up in the San Fernando Valley, trained at Los Angeles Trade-Technical College, and has spent the better part of two decades crawling through ductwork across California. He’s done jobs everywhere from older ranch homes near the Tower District to the newer builds out toward Clovis. What he learned in all those attics and crawlspaces is simple: the machine matters, but the person running it matters more.
That’s why every Linden Air Duct Fresno technician is background-checked, identity-verified, and photo-badged under the Threshold Standard. You get a name and photo before the visit, and a photo ID at the door. Every job gets a written price before work begins and a written 365-Day Done Right Promise when it’s finished. If a repair fails within that year, we return at no charge. And while Rotobrush is the system we’re talking about here, our techs work on Lennox, Trane, and Carrier duct systems every week, so we know how your Rotobrush setup fits into the broader picture. If Marcus wouldn’t leave it in his own house, he won’t leave it in yours.
FAQs
No. Independent cleaning performed with professional equipment does not void a Rotobrush product warranty, and we’re careful to follow manufacturer service guidelines on every job. We use OEM parts when you request them and document everything we do. If you have warranty concerns, ask us and we’ll walk through them before we start.
Yes. We stock common Rotobrush consumables including brush heads, vacuum bags, and seals, and we can source OEM or quality aftermarket parts for most models within a few days. If your unit needs a part we don’t carry, we’ll tell you the exact price and lead time before you commit to anything.
Most Fresno residential jobs are scheduled within a few days, and the cleaning itself usually takes three to five hours. If your Rotobrush unit needs parts, we’ll tell you upfront and give you a realistic timeline. We don’t rush jobs and we don’t promise same-day miracles, but you’ll always know when we’re coming.
That depends on the age of the unit and what’s failing. If the vacuum motor is strong and the frame is sound, replacing brush heads, belts, and seals usually makes sense. If the motor is tired and the drum is cracked, replacement may cost less than repeated repairs. We’ll give you a straight answer with numbers and let you decide. Call (559) 272-4989 and we’ll help you figure it out.
We show you. Every Rotobrush job includes before-and-after video inspection and photos of your own ducts, plus you’ll see the debris collected in the drum. The 365-Day Done Right Promise is in writing. If you’re not satisfied with what the video shows, we come back and address it.
Written by Marcus Veale, Owner, Linden Air Duct Fresno at Linden Air Duct Fresno, serving Fresno and nearby areas.