Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Abatement Technologies Air Duct Cleaning in Fresno: What to Know First
Abatement Technologies air duct cleaning in Fresno typically costs between $450 and $900 for a full residential system, depending on home size and duct configuration. We’re an independent Abatement Technologies service provider, not a manufacturer-authorized shop, and we complete most Fresno jobs in a single visit lasting four to seven hours. The price is put in writing before any work begins, and it does not change at the door.
This page is for homeowners in Fresno, Clovis, and the surrounding areas who own a home with Abatement Technologies filtration or duct components and need the ductwork actually cleaned, not just inspected. If you’ve noticed dust settling back onto surfaces within days of cleaning, louder airflow noise, or rooms that never seem to reach temperature, call us at (559) 272-4989 and Marcus Veale or one of our techs will walk you through what’s happening.
How Abatement Technologies Products Fail – and How We Fix Them
Abatement Technologies builds serious air purification and HVAC accessory equipment, but the ductwork attached to it still collects everything the Central Valley air pushes through it. Here’s what we find in Fresno homes.
- HEPA and media filter bypass on CAP and H-Series units. Abatement Technologies CAP-series portable air scrubbers and H-series HEPA units do their job only if the pre-filter and HEPA stages are seated correctly. In Fresno homes, we regularly find pre-filters installed backwards after a previous cleaning, which lets unfiltered air slip around the media and deposit dust directly into the supply ducts. We check filter orientation, gasket seating, and housing seals as part of every cleaning, then re-seat or replace what’s compromised.
- Dust loading downstream of Abatement air-handler plenums. Homes running Abatement Technologies filtration alongside a standard air handler often show heavy dust accumulation in the first six to eight feet of supply duct downstream of the unit. That’s not a filter failure; it’s turbulence in the plenum allowing particulates to drop out of the airstream. We clean those first few feet aggressively with negative-pressure extraction, because that’s where the bulk of the debris actually sits.
- Return-side restrictions on older Abatement ducted units. Abatement’s ducted HEPA units pull hard on the return side, and if the return registers are undersized or partially blocked, the negative pressure pulls dust from wall cavities and around register boots. We check every return register and boot seal on a job. When we find gaps, we seal them before cleaning so you’re not pulling attic or wall-cavity air into your living space afterward.
- VOC and carbon media saturation in Abatement purifiers. Abatement Technologies carbon and potassium permanganate media beds don’t fail with a bang; they fade. In Fresno, where summer ozone and wildfire smoke push those beds hard, a saturated carbon bed stops adsorbing and starts releasing captured VOCs back into the duct stream. We can’t regenerate carbon media, but we can tell you when it’s spent and the ducts need cleaning more often because of it.
- Condensate carryover on Abatement dehumidification coils. Abatement’s dehumidification coils collect moisture and, over multiple Fresno summers, mineral scale and bio-film. When the coil gets dirty, condensate droplets carry that material into the supply ducts during cooling cycles. We clean accessible coil surfaces as part of a full-system job and flag any coil that needs professional chemical treatment beyond what duct cleaning can address.
Styles & brands we work with
Our Abatement Technologies Air Duct Cleaning Process
We treat every Abatement Technologies system as a full-system job, not a vent-wiping exercise. Here’s the sequence.
- 1
Site inspection and written quote. We arrive, walk the mechanical room, check the Abatement unit’s filter condition and access points, and give you one flat price for the entire duct system before any tool comes off the truck.
- 2
Technician verification at the door. Your tech’s name and photo were sent to you before arrival. They show a photo ID badge before stepping inside. Every one of our techs is background-checked and identity-verified under the Threshold Standard.
- 3
System prep and protection. We lay down floor protection, confirm all registers are accessible, and confirm the Abatement unit is powered down so we’re not fighting a live blower while cleaning.
- 4
Negative-pressure extraction on supply and return. We connect a professional-grade extraction unit, typically Rotobrush or Nikro gear, to create negative pressure in the duct system. Aggressive agitation tools dislodge debris from duct walls, and the extraction pulls it out rather than blowing it through the house.
- 5
Component-level cleaning and filter check. Registers, boots, plenums, and accessible coil surfaces get cleaned. We inspect and re-seat all Abatement filter media, flag anything that’s spent or installed incorrectly, and note it on your service record.
- 6
Video inspection and walkthrough. We run a camera through the main runs so you can see the result. You’ll get before-and-after photos of your own ducts. Every repair we make carries a written guarantee, and if a covered repair fails within 365 days, we return at no charge.
See the difference
Before
After
Before
After
Before
AfterWhat Abatement Technologies Air Duct Cleaning Costs in Fresno
Real numbers, because you should know before you call.
- Typical single-family home, one HVAC system: $450 – $700
- Larger two-story home or extended duct runs: $650 – $900
- Commercial or multi-unit systems: priced per inspection, typically $900 and up
- Added dryer vent cleaning while we’re on site: $75 – $150
- Video inspection as a standalone diagnostic: $150, waived when you book a full cleaning
What moves the price: number of supply and return runs, accessibility of the air handler, how long it’s been since the last cleaning, and whether the duct system has multiple zones. We don’t charge per vent and we don’t quote a teaser number that balloons once the van is parked in your driveway. The price we hand you in writing is the price you pay. Call (559) 272-4989 for an exact quote on your Fresno home.
Why Fresno Homeowners Call Linden Air Duct Fresno for Abatement Technologies Work
Marcus Veale grew up in the San Fernando Valley and trained at Los Angeles Trade-Technical College before spending nearly two decades crawling through ductwork across California. He and his crew have worked Fresno homes from old ranch houses near Tower District to newer developments out toward Clovis, and the standard is the same on every job: “If I wouldn’t leave it in my own house, I won’t leave it in yours.”
Every Linden Air Duct Fresno job comes with the 365-Day Done Right Promise in writing. If the work isn’t right, we make it right. Every repair carries a written guarantee, and we return free if a covered repair fails. We also work on Lennox, Trane, and Carrier systems, so if you’ve got a mixed set of equipment, one crew can handle the whole house. The price is written before work starts, the tech’s name and photo arrive before the visit, and a real person answers the phone any time you call.
FAQs
No. Duct cleaning does not void an Abatement Technologies warranty, and we work in a way that respects manufacturer specs. We power down the unit, never force anything through filter housings, and use professional extraction equipment rather than high-pressure air that can damage duct liners. We’re an independent service provider, not an Abatement Technologies authorized shop, but we don’t do anything on a job that would give a manufacturer a reason to deny a claim.
In most Fresno homes we see, the answer is a bypass issue: filter media seated incorrectly, a housing seal that’s not tight, or the previous contractor cleaned registers and called it done without pulling debris from the main supply and return runs. We run a camera through the ducts as part of every full cleaning, so you’ll see what was actually cleaned and what wasn’t.
You’ll get before-and-after photos and video taken inside your own ductwork. Not stock photos. Not a checklist someone filled out in the truck. Your system, your house, your before and after.
In the Central Valley, with our dust loads, pollen seasons, and wildfire smoke pushes, we tell homeowners every three to five years is realistic. Homes with pets, recent remodeling, or residents with respiratory conditions often need it more frequently. If you can see dust on your registers or surfaces stay dusty within days of cleaning, the ducts are telling you something.
Because the price you’re quoted isn’t the price you’ll pay. This industry has a reputation built on low teaser numbers that inflate once the tech is in the driveway looking at your system. We give one written price before any work begins, and it doesn’t change. If a quote seems too cheap, ask what it actually covers: supply and return, boots, plenums, video inspection, the whole system or just a wipe-down of the registers. Call (559) 272-4989 for an honest quote, and you’ll get one.
Written by Marcus Veale, Owner, Linden Air Duct Fresno at Linden Air Duct Fresno, serving Fresno and nearby areas.